Insulator breakdown voltage

The atoms in insulating materials have very tightly-bound electrons, resisting free electron flow very well. However, insulators cannot resist indefinite amounts of voltage. With enough voltage applied, any insulating material will eventually succumb to the electrical "pressure" and electron flow will occur. However, unlike the situation with conductors where current is in a linear proportion to applied voltage (given a fixed resistance), current through an insulator is quite nonlinear: for voltages below a certain threshold level, virtually no electrons will flow, but if the voltage exceeds that threshold, there will be a rush of current.

Once current is forced through an insulating material, breakdown of that material's molecular structure has occurred. After breakdown, the material may or may not behave as an insulator any more, the molecular structure having been altered by the breach. There is usually a localized "puncture" of the insulating medium where the electrons flowed during breakdown.

Thickness of an insulating material plays a role in determining its breakdown voltage, otherwise known as dielectric strength. Specific dielectric strength is sometimes listed in terms of volts per mil (1/1000 of an inch), or kilovolts per inch (the two units are equivalent), but in practice it has been found that the relationship between breakdown voltage and thickness is not exactly linear. An insulator three times as thick has a dielectric strength slightly less than 3 times as much. However, for rough estimation use, volt-per-thickness ratings are fine.

Material*     Dielectric strength (kV/inch)    
=========================================== 
Vacuum ------------------- 20                     
Air ---------------------- 20 to 75             
Porcelain ---------------- 40 to 200           
Paraffin Wax ------------- 200 to 300          
Transformer Oil ---------- 400               
Bakelite ----------------- 300 to 550          
Rubber ------------------- 450 to 700        
Shellac ------------------ 900                
Paper -------------------- 1250                
Teflon ------------------- 1500                
Glass -------------------- 2000 to 3000         
Mica --------------------- 5000                 

* = Materials listed are specially prepared for electrical use.

• REVIEW:
• With a high enough applied voltage, electrons can be freed from the atoms of insulating materials, resulting in current through that material.
• The minimum voltage required to "violate" an insulator by forcing current through it is called the breakdown voltage, or dielectric strength.
• The thicker a piece of insulating material, the higher the breakdown voltage, all other factors being equal.
• Specific dielectric strength is typically rated in one of two equivalent units: volts per mil, or kilovolts per inch.